TIM-CO / CAL-RF How To Specify Semi-Rigid Cable Assemblies

TIM-CO/CAL-RF

How To Specify Semi-Rigid Cable Assemblies

When specifying the mechanical requirements of a semi-rigid cable assembly, the illustration below can be used as an example of the preferred method for defining measurements. Complete electrical requirements should also be listed on the drawing to assure an accurate and timely response. For cost effective assemblies, keep all inside bend radii the same.

Connector Type (C1) ___________________________	VSWR _______________________________________ (Optional)
Connector Type (C2) ___________________________	Frequency Range ______________________________ (Optional)
Cable Type ___________________________________	Return Loss ___________________________________ (Optional)
Cable Marker ________________________________	Insertion Loss _________________________________ (Optional)
Delay Required _______________________________ (Optional)	Other ________________________________________
Tolerance of Delay ____________________________ (Optional)	______________________________________________

Click Here for a Printable Form

FAX : (818) 340-6159

CONTACT INFORMATION

Tim-Co Component Sales/ California RF Components
7001 Eton Avenue
Canoga Park, CA 91303

Phone - Tim-Co:
or
Phone - CAL-RF:
Fax:

(818) 992-5040
(800) 238-4626
(818) 888-4851
(818) 340-6159

E-MAILS

Contact Our Salesperson Directly At:

Inside Sales	E-mail

Danny Soliz
Ron Reichick
J.J. Clarizio
Engineering

County	Engineering Field Sales	Phone
LA North and Ventura	Kerry Jacobs	805-300-7695
LA South and Orange	Joe Casmero	714-598-9757

We accept the following credit cards ...